Recently a client wanted a port and burst Layer 2 service, similar to what Megaport offers in many parts of the world. The customer wanted to pay a fixed port fee and a variable fee for bursting traffic. In the past this setup used Layer 2 Switched Ethernet. The drawback was the cost of Ethernet switching, network management, and the possibility that the provider would severely overbook the service. Making money on such a service is very hard without overbooking.
However, most large capacity providers just sell dumb, Layer 1 pipes. So until recently smaller ISPs had few options. Either Megaport or standard chunky Layer 1 waves. The challenge is that many ISPs has peak traffic well below standard 100G wave services, but above 10G. So rightsizing the network is extremely hard.
The good news is that the Optical Internetworking Forum developed the FlexE interface standard, which I view as a Layer 1.5 option. It enjoys all the advantages of layer 1 in terms of hard traffic separation, optical latency, and zero jitter, but is granular in one gigabit increments, yet has that beloved Ethernet framing.
To be clear, FlexE does not allow bursting. Its advantage is Layer 1 performance with Ethernet framing and the bandwidth granularity that previously required Layer 2 switching. So FlexE eliminates the Ethernet switch. So the network is simpler, a little less expensive, and has fewer points of failure. But the big advantage is granularity and the ability to quickly upgrade the service via network management software. No physical changes are required.
This is a good option for a startup ISP. They can take a 100G or 10G port and start as low as a 1 gigabit and scale as traffic grows. Hauwei has an excellent introduction to the topic: https://info.support.huawei.com/info-finder/encyclopedia/en/FlexE.html.
Comments
Post a Comment